EIM TEC2000 Actuator


TEC2000 provides freedom to choose from any of three Tri-Set configuration setup methods:

• Control knobs on either the Local Display Module (LDM) or on the optional Remote Display Module (RDM), which can be mounted up to 1200 meters (4000 ft) away from the actuator.
• PC or PDA via RS-485 link to the actuator, or via the IrDA port, utilizing EIM’s TecLinc Windows®-based software.*
• EIM’s optional keychain “Clicker” device. The “Clicker,” an IrDA controller, has four buttons that correspond to the Yes, No, Back and Next functions of the local control knobs. The entire actuator configuration process can be completed using this compact tool. (Clicker not available in Japan or England).


TEC2000 actuators are available for three-phase (three-wire) and single-phase power sources:

Three-phase 50Hz
220, 230, 240, 380, 400, 415, 440, 460, 480, 500, 550, 575, 600, and 690 volts
Three-phase 60Hz
208, 220, 230, 380, 440, 460, 480, 575, 600, and 690 volts
Single-phase 50Hz
110, 115, 220, 230 and 240 volts
Single-phase 60Hz
115, 120, 208, 220 and 230 volts
The nominal operating voltage must be specified at time of order. Published actuator performance data is for power supply variations of ± 10% voltage and ± 5Hz frequency. If power supply variations are outside of these limits, please consult EIM to ensure that actuator performance meets your requirements.


Categories: ,